LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2016 >> XJR L >> Repair and Diagnosis >> External Pages >> Different car >> Section 17 (Front Drive Axle/Differential -- XJ/X351) >> Front Drive Axle/Differential >> Removal And Installation >> Drive Pinion Seal (G1557143) >> Removal

Drive Pinion Seal (G1557143): Removal

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2017 Jaguar XJ, 2016 Jaguar XJ, 2015 Jaguar XJ, 2014 Jaguar XJ, and 2013 Jaguar XJ. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: The drive pinion seal must only be renewed once.
NOTE: Some illustrations may show the final drive unit removed for clarity.
  1. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.

    Raise and support the vehicle.

  2. Refer to: Differential Draining and Filling  (General Procedures).
  3. Refer to: Front Driveshaft - AWD (Removal and Installation).
  4. G11284207
    • Measure the depth of the pinion nut on the pinion shaft.
    • Note measurement for installation.
  5. CAUTION: This step must be carried out to make sure that the drive pinion nut is correctly tightened on assembly.
    G11284208

    Accurately scribe a line to mark the drive pinion shaft to the drive pinion nut and pinion flange.

  6. G11284209

    Discard the drive pinion nut retainer.

    Special Tool(s):  205-053

  7. CAUTION: Make sure only a bolt is used with the special tool, to draw the drive pinion flange off the drive pinion shaft.
    G11284210
  8. G11284211

    Special Tool(s):  205-822, 100-012

scientia non olet · About LEMON Manuals