LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2016 >> XJR L >> Repair and Diagnosis >> External Pages >> Different car >> Section 17 (Front Drive Axle/Differential -- XJ/X351) >> Front Drive Axle/Differential >> Removal And Installation >> Drive Pinion Seal (G1557143) >> Installation

Drive Pinion Seal (G1557143): Installation

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2017 Jaguar XJ, 2016 Jaguar XJ, 2015 Jaguar XJ, 2014 Jaguar XJ, and 2013 Jaguar XJ. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean the drive pinion flange.
  2. Clean the drive pinion seal mating faces.
  3. G11284212
  4. CAUTION: Make sure the drive pinion flange scribed marks are aligned.

    Install the drive pinion flange.

  5. CAUTION:
    • Make sure the mark on the drive pinion nut is never tightened short of the scribed mark on the drive pinion shaft.
    • Make sure the drive pinion flange has no end float and is free to rotate.
    • Make sure that the scribed mark on the pinion drive nut is no more than a maximum of 2.5 degrees past the scribed mark on the differential housing.
    G11284209
    • Special Tool(s):  205-053
    • Install nut to previously noted number of turns.
    • Measure the depth of the pinion nut on the pinion shaft.
  6. Refer to: Front Driveshaft - AWD (Installation).
  7. CAUTION: Make sure the correct specification and quantity of oil is used.

    Refer to: Differential Draining and Filling  (General Procedures).

scientia non olet · About LEMON Manuals