Extension Housing Seal - V6 S/C 3.0L Petrol/V8 5.0L Petrol/V8 S/C 5.0L Petrol (G1571598): Removal
WARNING: This page is about a different car, the 2015 Jaguar XJ, 2014 Jaguar XJ, and 2013 Jaguar XJ. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Some variation in the illustrations may occur, but the essential information is always correct.
- Refer to: Battery Disconnect and Connect (General Procedures).
-
WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
-
NOTE: Mark the position of the driveshaft on the transmission flange.
-
CAUTION:
- Make sure that the driveshaft is supported with suitable retaining straps.
- Discard the bolts.
Tie aside with a suitable tie strap.
-
Refer to TRANSMISSION SUPPORT INSULATOR - V6 3.0L PETROL/V6 S/C 3.0L PETROL/V8 5.0L PETROL/V8 S/C 5.0L PETROL (G1271945) (Removal and Installation).
-
CAUTION: Discard the nut.
Special Tool(s): 205-053
Special Tool(s): 303-D121
-
CAUTION: Discard the seal.
Special Tool(s): 100-012, 100-012-01, 308-375