LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2016 >> XJR L >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Fuel Charging & Controls - V8 N/A 5.0L Petrol -- XJ/X351) >> Fuel Charging And Controls - V8 5.0L Petrol >> Removal And Installation >> Fuel Rail LH (G1280001) >> Removal

Fuel Rail LH (G1280001): Removal

WARNING: This page is about a different car, the 2013 Jaguar XJ, 2012 Jaguar XJ, 2011 Jaguar XJ, and 2010 Jaguar XJ. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Make sure that tools and equipment are clean, free of foreign material and lubricant.
NOTE:
  • Removal steps in this procedure may contain installation details.
  • Some variation in the illustrations may occur, but the essential information is always correct.
  1. Refer to PETROL AND PETROL-ETHANOL FUEL SYSTEMS HEALTH AND SAFETY PRECAUTIONS .
  2. Refer to FUEL SYSTEM PRESSURE RELEASE - GTDI 2.0L PETROL/V6 S/C 3.0L PETROL/V8 5.0L PETROL/V8 S/C 5.0L PETROL (G1084829) .
  3. Refer to BATTERY DISCONNECT AND CONNECT .
  4. Refer to ENGINE COVER - V8 5.0L PETROL/V8 S/C 5.0L PETROL .
  5. Refer to Secondary Bulkhead Panel LH .
  6. Refer to FUEL INJECTION COMPONENT CLEANING (G1202495) .
  7. G11288033
  8. CAUTION: Be prepared to collect escaping fluids.
    G11288034
  9. G11285512
  10. CAUTION:
    • Be prepared to collect escaping fluids.
    • Make sure that all openings are sealed. Use new blanking caps.
    G11285092
  11. G11288037
  12. G11288038
  13. NOTE: RH shown LH similar.
    G11288039

    Special Tool(s):  303-1450

  14. CAUTION: Make a note of the fuel injector clamp alignment to the fuel rail prior to removal.
    G11288040
  15. CAUTION:
    • Make sure that the special tool is located correctly to the fuel injector prior to removing the fuel injector.
    • Make sure that the special tool is held square to the fuel injector during removal.
    • Make sure that all open ports are covered to prevent any foreign material ingress.
    G11288041

    Special Tool(s):  310-197

  16. CAUTION:
    • If new fuel injectors are installed, a new injector clamp must be installed.
    • If the fuel injector is being removed without a new component being installed, the fuel injector clamp must remain with the fuel injector it is removed with.
    G11288042
  17. CAUTION:
    • Do not use a knife to remove the Teflon seal as damage could occur to the fuel injector.
    • Do not cut the Teflon seal to deep as damage could occur to the fuel injector.
    • Pinch the Teflon seal to allow the tool to cut the Teflon seal without damaging the fuel injector.
    G11288043
  18. CAUTION: Do not use any sharp tools to remove the O-ring seal as damage could occur to the fuel injector.
    G11288044
scientia non olet · About LEMON Manuals