LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2016 >> XJR L >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (Fuel Charging & Controls - V6 S/C 3.0L Petrol -- XJ/X351) >> Fuel Charging And Controls - V6 S/C 3.0 L Petrol >> Removal And Installation >> High Pressure Fuel Pump 2 - RWD (G1280007) >> Removal

High Pressure Fuel Pump 2 - RWD (G1280007): Removal

WARNING: This page is about a different car, the 2017 Jaguar XJ, 2016 Jaguar XJ, 2015 Jaguar XJ, 2014 Jaguar XJ, and 2013 Jaguar XJ. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Make sure that tools and equipment are clean, free of foreign material and lubricant.
NOTE:
  • Removal steps in this procedure may contain installation details.
  • Some variation in the illustrations may occur, but the essential information is always correct.
  1. Refer to: PETROL AND PETROL-ETHANOL FUEL SYSTEMS HEALTH AND SAFETY PRECAUTIONS .
  2. Refer to: FUEL SYSTEM PRESSURE RELEASE - V6 S/C 3.0L PETROL/V8 5.0L PETROL/V8 S/C 5.0L PETROL (G1084829) (General Procedures).
  3. Refer to: BATTERY DISCONNECT AND CONNECT (General Procedures).
  4. Refer to: ENGINE COVER - V6 S/C 3.0L PETROL (G1267472) .
  5. Refer to: ENGINE OIL DRAINING AND FILLING (G1779627) (General Procedures).
  6. Refer to: FUEL INJECTION COMPONENT CLEANING .
  7. G11288287
  8. CAUTION: Be prepared to collect escaping fluids.
    G11288288
  9. Refer to: AIR CLEANER RH (G1271880) .
  10. CAUTION:
    • Be prepared to collect escaping fluids.
    • Make sure that all openings are sealed. Use new blanking caps.
    G11286716
  11. G11288122
  12. CAUTION:
    • Be prepared to collect escaping fluids.
    • Make sure that all openings are sealed. Use new blanking caps.
    G11288291
  13. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.

    Raise and support the vehicle.

  14. Refer to: ENGINE MOUNT RH (G1271918) .
  15. Refer to: GENERATOR - V8 5.0L PETROL (G1267426) .
  16. NOTE: Engine shown removed for clarity.
    G11288124
  17. NOTE: Engine shown removed for clarity.
    G11285201
  18. NOTE: Engine shown removed for clarity.
    G11288126
  19. CAUTION: Make sure that all openings are sealed. Use new blanking caps.
    G11288127
  20. CAUTION:
    • Remove and discard the high-pressure fuel supply lines.
    • Be prepared to collect escaping fluids.
    • Make sure that all openings are sealed. Use new blanking caps.
    NOTE: Engine shown removed for clarity.
    G11285157
  21. G11288129
  22. CAUTION: Be prepared to collect escaping fluids.
    G11288130

    Loosen the Torx screws a turn each at a time.

  23. CAUTION: Be prepared to collect escaping fluids.
    G11288131