Fuel Filler Pipe (NAS)
| ITEM | DESCRIPTION |
|---|---|
| 1 | Check valve assembly |
| 2 | Fuel filler neck |
| 3 | Fuel filler cap |
| 4 | Fuel filler cap lanyard |
| 5 | Diagnostic Module Tank Leakage (DMTL) breather hose |
| 6 | Diagnostic Module Tank Leakage (DMTL) filter |
| 7 | Fuel filler pipe |
| 8 | Diagnostic Module Tank Leakage (DMTL) pipe |
| 9 | Connection to charcoal canister |
| 10 | Hose clamp (2 off) |
| 11 | Fuel filler hose |
| 12 | Hose connection with fuel tank inlet check valve |
The fuel filler head is positioned at the rear of the vehicle, above the right rear wheel. The filler head is covered by a molded plastic cover which is electrically locked when the vehicle is locked. The filler cap is a conventional screw in type which is secured to the vehicle with a lanyard.
The filler head is stainless steel fabrication which is secured to the vehicle body with 2 brackets and a location lug on the filler bowl. The formed pipe locates in a short flexible hose attached to the tank which is secured with worm drive hose clamps at each end. The hose, in turn, connects with a fuel tank inlet check valve which prevents fuel within the tank re-entering the fuel filler hose and pipe.