Fuel Tank
| ITEM | DESCRIPTION |
|---|---|
| 1 | Fuel Pump Driver Module (FPDM) |
| 2 | Evaporative emissions canister |
| 3 | Diagnostic Module Tank Leakage (DMTL) pump (NAS only) |
| 4 | Evaporative emissions pipe |
| 5 | Pipe - Evaporative emissions canister to purge valve |
| 6 | Vapor pressure control valve |
| 7 | Pipe connection - Evaporative emissions canister to purge valve |
| 8 | Fuel supply to engine |
| 9 | Fuel level sensor float |
| 10 | Fuel pick up left side of tank |
| 11 | Fuel level sensor - 'B' |
| 12 | Liquid Vapor Separator (LVS) and vent valve |
| 13 | Fuel level sensor float |
| 14 | Fuel lift pump outlet connection |
| 15 | Fuel filter |
| 16 | Fuel level sensor - 'A' |
| 17 | Fuel supply connection from pump to manifold |
| 18 | Fuel pump module |
| 19 | Manifold |
| 20 | Fuel supply outlet connection to engine |
| 21 | Fuel pressure sensor - Low Pressure (LP) fuel system |
| 22 | Fuel tank inlet check valve |
| 23 | Fuel filler hose |
The fuel tank is a saddle type tank, blow molded from High Density Poly Ethylene. The tank is located forward of the rear suspension and is mounted in a shield and secured to the vehicle using two metal straps. The tank is a sealed unit with the only internal access being through the fuel pump module aperture on the top of the tank.
The fuel pump module flange has six pin internal and external connectors which provide the electrical connections for the fuel pump and both fuel level sensors. A quick release connector provides for the connection of the fuel supply pipe.
The flange is fitted with a locking ring and seal. The seal locates in a groove on the tank. The locking ring locates and clamps on the encapsulated ring that is molded into the fuel tank. The flange has a tag which locates in the top of the tank to ensure correct orientation.
A carrier within the tank provides for the mounting of the passive side jet pump tube, vent valve and Liquid Vapor Separator (LVS), level sensors and passive side drain. A roll over valve is welded externally at the rear of the tank and is connected into the vent pipe via a tee-piece.