LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2015 >> XJR Base >> Repair and Diagnosis >> Engine Mechanical >> Blowers, Superchargers & Turbochargers >> Fuel Charging & Controls - V8 S/C 5.0L Petrol -- XJ/X351 >> Fuel Charging And Controls - V8 S/C 5.0 L Petrol >> Removal And Installation >> Fuel Rail LH (G1280005) >> Installation

Fuel Rail LH (G1280005): Installation

  1. G11288044

    Install new O-ring seals.

  2. G11288046

    Install new Teflon seals.

    Special Tool(s):  310-198

  3. G11288047

    Special Tool(s):  310-199

  4. CAUTION: If the original fuel injector is being installed, the original fuel injector clamp must installed with the fuel injector it was removed with.
    G11288042
  5. CAUTION: If a new cylinder head has been installed then the special tool 310-200-02 without the thread must be used to install the fuel rail.
    G11288049

    Special Tool(s):  310-200-01, 310-200-02

  6. CAUTION:
    • Make sure that the area around the open fuel injector ports are clean and free of foreign material and lubricant prior to installing the fuel injector.
    • When Installing the fuel injector(s), make sure that the Teflon seal is clean and free of foreign material and lubricant.
    G11288050
  7. CAUTION:
    • If new fuel injectors are installed, a new injector clamp must be installed
    • Make sure that the fuel injector is aligned and installed into the fuel rail correctly, as noted in the removal step.
    • Tighten the fuel rail retaining bolts a turn at a time until the correct torque is achieved.
    NOTE: Lubricate the fuel injector O-ring seals with clean engine oil.
    G11288051

    Torque Specification: 20 Nm 

  8. G11288052

    Special Tool(s):  310-200-01, 310-200-02

  9. G11288053

    Torque Specification: 20 Nm 

  10. NOTE: Tighten in the sequence indicated.
    G11288054

    Torque Specifications: 

    Bolt 2 30 Nm 

    Bolt 3 30 Nm 

    Bolt 1 30 Nm 

    Bolt 4 30 Nm 

  11. NOTE: RH shown LH similar.
    G11288039

    Special Tool(s):  303-1450

    Torque Specification: 20 Nm 

  12. G11288038

    Torque Specification: 7 Nm 

  13. G11288057
  14. NOTE:
    • Lubricate the union threads with clean engine oil.
    • Do not tighten at this stage.
    • Remove and discard the blanking caps.
    G11286716
  15. G11286716

    Torque Specifications: 

    union 21 Nm 

    bolts 8 Nm 

  16. G11286769

    Torque Specification: 21 Nm 

  17. G11288198
  18. G11288197
  19. G11288196
  20. G11288195
  21. G11288194
  22. Refer to: Secondary Bulkhead Panel LH .
  23. Refer to: ENGINE COVER - V8 5.0L PETROL/V8 S/C 5.0L PETROL .
  24. Refer to: BATTERY DISCONNECT AND CONNECT .
scientia non olet · About LEMON Manuals