Removal And Installation: Removal

WARNING: This page is about a different car, the 2015 Jaguar XF, 2014 Jaguar XF, and 2013 Jaguar XF. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Check all timing components for wear and install new components if required.

NOTE:

Some variation in the illustrations may occur, but the essential information is always correct.
Some illustrations may show the engine removed for clarity.

Refer to: Battery Disconnect and Connect (Battery, Mounting and Cables, General Procedures).
WARNING: Make sure to support the vehicle with axle stands.

Raise and support the vehicle.
Refer to: Timing Cover (Engine - V6 S/C 3.0L Petrol, Removal and Installation).
CAUTION: Only rotate the crankshaft clockwise.

Install the special tool.

Special Tool(s): JLR-303-1303
CAUTION: If the variable valve timing (VVT) units are knocked or dropped then the VVT must be replaced.

Remove the timing chain with the VVT units.
CAUTION: If the VVT is knocked or dropped then the VVT must be replaced.

Remove the timing chain with the VVT units.
CAUTION: Discard the friction washer.