LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2015 >> XFR-S >> Repair and Diagnosis >> External Pages >> Different car >> Section 79 (Engine - V6 S/C 3.0L Petrol -- XF/X250) >> Engine - V6 S/C 3.0L Petrol >> Left Engine Mount - RWD (G1557018) >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different car, the 2015 Jaguar XF, 2014 Jaguar XF, and 2013 Jaguar XF. However, it is still accessible from the selected car via links, so may be relevant.

All vehicles 

  1. G11415647
    • Install a new nut and tighten to 48 Nm.
  2. G11415648

    Torque Specification: 48 Nm 

  3. G11415649
    • Torque Specification: 63 Nm 
    • Install a new locknut.
  4. G11415650

    Torque Specification: 18 Nm 

  5. G11415651

    Torque Specification: 18 Nm 

  6. G11415652

    Torque Specification: 10 Nm 

    Left-hand drive vehicles 

  7. G11415653

    Torque Specification: 100 Nm 

  8. NOTE: Make sure that this component is installed to the noted removal position.
    G11415654
    • Torque Specification: 35 Nm 
    • Right-hand side shown, left-hand side similar.
  9. G11415655

    All vehicles 

  10. Refer to: Air Conditioning System Recovery, Evacuation and Charging (Climate Control System - General Information, General Procedures).

  11. Refer to: Air Deflector (Front End Body Panels, Removal and Installation).
  12. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.

    Lower the vehicle on the lift.

  13. Refer to: Battery Disconnect and Connect (Battery, Mounting and Cables, General Procedures).