Special Tool(S)
WARNING: This page is about a different car, the 2015 Jaguar XF, 2014 Jaguar XF, and 2013 Jaguar XF. However, it is still accessible from the selected car via links, so may be relevant.
| 303-021 Engine support bracket |
|
| 303-1435 Engine Lifting Brackets Rear |
|
| 303-1436 Engine Lifting Bracket Front |
NOTE:
- Some variation in the illustrations may occur, but the essential information is always correct.
- Some illustrations may show the engine removed for clarity.
- Refer to: Battery Disconnect and Connect (Battery, Mounting and Cables, General Procedures).
- Refer to: Cooling System Partial Draining, Filling and Bleeding (V6 S/C 3.0L Petrol, General Procedures).
- Refer to: Air Conditioning System Recovery, Evacuation and Charging (Climate Control System - General Information, General Procedures).
- Refer to: Hood (Front End Body Panels, Removal and Installation).
- Refer to: Secondary Bulkhead Left Panel - TDV6 3.0L Diesel/V6 S/C 3.0L Petrol/V8 N/A 5.0L Petrol/V8 S/C 5.0L Petrol (Front End Body Panels, Removal and Installation).
- Refer to: Secondary Bulkhead Right Panel - TDV6 3.0L Diesel/V6 S/C 3.0L Petrol/V8 S/C 5.0L Petrol (Front End Body Panels, Removal and Installation).
- Refer to: Cooling Fan Motor and Shroud (V6 S/C 3.0L Petrol, Removal and Installation).
- Refer to: Transmission (Automatic Transmission/Transaxle - V6 S/C 3.0L Petrol, AWD, Removal).
-
WARNING: Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel related components. Highly flammable vapors are always present and may ignite. Failure to follow these instructions may result in personal injury.CAUTION: Be prepared to collect escaping fuel.
- Siphon the fluid from the power steering reservoir.
-
CAUTION: Be prepared to collect escaping fluids.
-
WARNING: Be prepared to collect escaping fluids.NOTE: Discard the sealing washers.
-
NOTE: Left Hand illustration shown, Right Hand is similar.
-
CAUTION: Be prepared to collect escaping coolant.
-
CAUTION: Be prepared to collect escaping coolant.
-
CAUTION: Be prepared to collect escaping coolant.
-
CAUTION: Be prepared to collect escaping coolant.
-
CAUTION: Be prepared to collect escaping coolant.
-
CAUTION: Be prepared to collect escaping coolant.
Special Tool(s): 303-1435
Torque Specification: 25 Nm
-
CAUTION: Be prepared to collect escaping coolant.
Special Tool(s): 303-1436
Torque Specification: 25 Nm
-
CAUTION: Be prepared to collect escaping coolant.
-
NOTE: Remove and discard the O-ring seal.
-
NOTE: Remove and discard the O-ring seal.
-
NOTE: Remove and discard the O-ring seal.
Remove the special tool.
Special Tool(s): 303-021
-
NOTE: This step requires the aid of another technician.
Using a suitable tool, remove the engine.
Special Tool(s): 303-1435, 303-1436