LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2015 >> XFR-S >> Repair and Diagnosis >> External Pages >> Different car >> Section 73 (Climate Control System - General Information -- XF/X250) >> Climate Control System - General Information >> General Procedures >> Inspection And Assembly Requirements (G61412)

Inspection And Assembly Requirements (G61412)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2015 Jaguar XFR, 2015 Jaguar XF, 2014 Jaguar XFR, 2014 Jaguar XF, and 2013 Jaguar XFR. However, it is still accessible from the selected car via links, so may be relevant.

Procedure 

  1. Check for leaks using ultraviolet (UV) Lamp.

    For additional information, refer to FLUORESCENT DYE LEAK DETECTION (G179002)  .

  2. NOTE:
    • Any time a hose or component connection leak is observed, the component and fitting must be separated, cleaned and a new O-ring fitted and lubricated with air conditioning compressor oil. For additional information, refer to SPECIFICATIONS  .
    • When separating A/C joints, cap the open connections immediately. Do not leave open to atmosphere.

    O-ring seal surfaces must be free of dirt, lint, burrs and scratches. The O-ring and connector should be lubricated with air conditioning compressor oil.

    For additional information, refer to SPECIFICATIONS  .