LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2015 >> XFR-S >> Repair and Diagnosis >> External Pages >> Different car >> Section 36 (Automatic Transmission/Transaxle External Controls (V8 5.0L Petrol/V8 S/C 5.0L Petrol)) >> Automatic Transmission/Transaxle External Controls - V8 5.0L Petrol/V8 S/C 5.0L Petrol >> Diagnosis And Testing >> External Controls >> Inspection And Verification

Inspection And Verification

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XFR, 2015 Jaguar XF, 2014 Jaguar XFR, 2014 Jaguar XF, and 2013 Jaguar XFR. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Diagnosis by substitution from a donor vehicle is NOT  acceptable. Substitution of control modules does not guarantee confirmation of a fault and may also cause additional faults in the vehicle being checked and/or the donor vehicle
NOTE: Check and rectify basic faults before beginning diagnostic routines involving pinpoint tests

Visual Inspection 

  1. Verify the customer concern
  2. Visually inspect for obvious signs of mechanical or electrical damage
    MECHANICAL ELECTRICAL
    • Check for stuck/jammed switches and buttons
    • Visibly damaged or worn components
    • Loose or missing fasteners
    • Fuses
    • Wiring harness
    • Electrical connector(s)
    • Sensor(s)
    • Transmission shift module
    • Engine control module
    • Transmission control module
  3. If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step
  4. If the cause is not visually evident, check for diagnostic trouble codes (DTCs) and refer to the DTC index