LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Coupe >> Repair and Diagnosis >> Suspension >> Wheels & Tire System >> Wheels & Tires -- XK/X150 >> Wheels And Tires >> Tire Pressure Monitoring System Module - Convertible (G542801) >> Removal And Installation >> Installation

Removal And Installation: Installation

  1. Install the tire pressure monitoring module.
    • Tighten the nuts to 10 Nm (7 lb.ft).
    • Connect the electrical connectors.
  2. Secure the auxiliary junction box mounting bracket.
    • Tighten the nuts to 10 Nm (7 lb.ft).
  3. Install the rear seat RH backrest retaining bracket.
    • Tighten the nuts and bolts to 10 Nm (7 lb.ft).
  4. Install the RH roll over protection unit.
    • Tighten the Torx bolts to 25 Nm (18 lb.ft).
    • Connect the electrical connector.
  5. Install the LH roll over protection unit.
  6. Connect the battery ground cable and install the cover. For additional information, refer to: BATTERY AND CHARGING SYSTEM - GENERAL INFORMATION .
  7. Using WDS, configure a new module.
scientia non olet · About LEMON Manuals