LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 91 (Electronic Engine Controls - V8 S/C 5.0L Petrol -- XK/X150) >> Electronic Engine Controls - V8 S/C 5.0L Petrol >> Right Heated Oxygen Sensor >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2014 Jaguar XKR-S, 2014 Jaguar XKR, and 2013 Jaguar XKR-S. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION:
    • Make sure the anti-seize compound does not contact the HO2S tip.
    • If accidentally dropped or knocked install a new sensor.
    • Make sure the HO2S wiring harness is not twisted more than 180 degrees and is not in contact with either the exhaust or driveshaft.
    NOTE: If the original sensor is to be installed, apply lubricant meeting specification ESE-M12A4-A to the thread of the sensor.

  1. To install, reverse the removal procedure.

    2. NOTE: For NAS vehicles only.

  2. If required, carry out a long drive cycle.

    Refer to: Powertrain Control Module (PCM) Long Drive Cycle Self-Test

scientia non olet · About LEMON Manuals