LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 91 (Electronic Engine Controls - V8 S/C 5.0L Petrol -- XK/X150) >> Electronic Engine Controls - V8 S/C 5.0L Petrol >> Electronic Engine Controls DTC: Heated Oxygen Sensors (Ho2S) >> Diagnosis And Testing >> Inspection And Verification >> Notes

Inspection And Verification: Notes

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2014 Jaguar XKR-S, 2014 Jaguar XKR, and 2013 Jaguar XKR-S. However, it is still accessible from the selected car via links, so may be relevant.
  1. Verify the customer concern.
  2. Visually inspect for obvious signs of mechanical or electrical damage.

    VISUAL INSPECTION 

    MECHANICAL ELECTRICAL
    • Heated Oxygen Sensor (HO2S) incorrect installation
    • Heated Oxygen Sensor (HO2S) contamination by incorrect fuel or oil
    • Heated Oxygen Sensor (HO2S) degraded
    • Exhaust system leakage
    • Exhaust system restriction
    • Air intake system leakage
    • Mass air flow sensor contamination
    • Incorrect fuel pressure
    • Pipe detached or union leakage between intake manifold and cylinder head
    • Connector is disconnected, connector pin is backed out, connector pin corrosion
    • Fuses
    • Wiring harness
    • Electrical connector(s)
  3. If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.
  4. Using the approved diagnostic tool, check for Diagnostic Trouble Codes (DTCs). 
  5. Refer to the Diagnostic Trouble Code Index DTC: Engine Control Module (ECM) 5.0L SC V8 - AJ133 -- XK/X150