LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 89 (Engine - V8 S/C 5.0L Petrol) >> Engine (V8 S/C 5.0L Petrol) >> Removal and Installation >> Timing Cover >> Installation

Timing Cover: Installation

WARNING: This page is about a different car, the 2011 Jaguar XKR175, 2011 Jaguar XKR, and 2010 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply RTV sealant WSE-M4G323-A6 (Loctite 5901G) to the areas shown, and tighten the bolts within 7 minutes.
    GJ0012155
  2. Apply RTV sealant WSE-M4G323-A6 (Loctite 5901G) to the areas shown, and tighten the bolts within 7 minutes.
    GJ0012156
    3. NOTE: Tighten the bolts in the indicated sequence.
  3. Torque: 12 Nm
    GJ0012157
    4. NOTE: Tighten the bolts in the indicated sequence.
  4. Torque: 12 Nm
    GJ0012158
  5. Apply RTV sealant WSE-M4G323-A6 (Loctite 5901G) to the areas shown, and tighten the bolts within 7 minutes.
    GJ0012159
    6. CAUTION: Make sure that the mating faces are clean and free of foreign material.
  6. Install the bolts, but do not tighten fully at this stage.

    Special Tool(s): 303-1433

    GJ0012160
    7. NOTE: Tighten the bolts in the indicated sequence.
  7. Torque:

    M6 12 Nm

    M8 20 Nm

    GJ0012161
  8. Remove the special tool.
  9. Torque: 12 Nm
    GJ0012162
  10. Torque: 12 Nm
    GJ0012153
  11. Torque: 12 Nm
    GJ0012152
  12. Refer to: Crankshaft Pulley  .
  13. Refer to: Valve Cover RH  .
  14. Refer to: Valve Cover LH  .
  15. Refer to: THERMOSTAT HOUSING - V8 S/C 5.0L PETROL .
  16. Refer to: ACCESSORY DRIVE BELT TENSIONER (V8 S/C 5.0L PETROL) .
  17. Refer to: ACCESSORY DRIVE BELT IDLER PULLEY (V8 S/C 5.0L PETROL) .
  18. Refer to: BATTERY DISCONNECT AND CONNECT .
scientia non olet · About LEMON Manuals