LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 89 (Engine - V8 S/C 5.0L Petrol) >> Engine (V8 S/C 5.0L Petrol) >> Removal and Installation >> Oil Pump >> Installation

Oil Pump: Installation

WARNING: This page is about a different car, the 2011 Jaguar XKR175, 2011 Jaguar XKR, and 2010 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Lubricate and install the new O-ring seals.
  1. See figure.
    GJ0012881
    2. NOTE: Lubricate and install the new O-ring seals.
  2. Torque:

    M8 25 Nm

    M6 12 Nm

    GJ0012882
    3. NOTE: Lubricate and install the new O-ring seals.
  3. See figure.
    GJ0012883
  4. Torque: 12 Nm
    GJ0012884
  5. Torque: 21 Nm
    GJ0012878
    6. NOTE: Tsubaki timing drive only.
  6. Install the lower timing chain making sure the coloured chain links align correctly with the fuel rail high-pressure fuel pumps camshaft and crankshaft sprocket markings.
    GJ0012885
    7. CAUTION: Make sure that the tensioner spring is correctly located.
    NOTE: Tsubaki timing drive only.
  7. Torque: 21 Nm
    GJ0012876
    8. NOTE: INA timing drive only.
  8. Install the lower timing chain making sure the coloured chain links align correctly with the fuel rail high-pressure fuel pumps camshaft and crankshaft sprocket markings.
    GJ0012886
    9. CAUTION: Make sure that the tensioner spring is correctly located.
    NOTE: INA timing drive only.
  9. Torque: 21 Nm
    GJ0012877
  10. Refer to: Oil Pan Extension  .
  11. Refer to: BATTERY DISCONNECT AND CONNECT .
scientia non olet · About LEMON Manuals