LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 89 (Engine - V8 S/C 5.0L Petrol) >> Engine (V8 S/C 5.0L Petrol) >> Removal and Installation >> Exhaust Manifold RH >> Installation

Exhaust Manifold RH: Installation

WARNING: This page is about a different car, the 2011 Jaguar XKR175, 2011 Jaguar XKR, and 2010 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
  1. Torque: 45 Nm
    GJ0012121
    2. NOTE: Install a new gasket.
  2. Install the special tool.
    GJ0012122
    3. NOTE: If a new cylinder head is installed use the special tools in the illustration.
  3. Install the special tool.
    4. CAUTION: Make sure that new bolts are installed.
    NOTE: Install the spacers in the noted position.
  4. Torque: 10 Nm
    GJ0012124
  5. Remove the special tool.
    GJ0012125
    6. CAUTION: Make sure that new bolts are installed.
    NOTE: Install the spacers in the noted position.
  6. Torque: 10 Nm
    GJ0012126
  7. Torque: 18 Nm
    GJ0012127
  8. See figure.
    GJ0023321
  9. Torque: 12 Nm
    GJ0023322
  10. Torque: 48 Nm
    GJ0023323
    11. CAUTION: Discard the bolt.
  11. Torque: 35 Nm
    GJ0023317
  12. Torque: 100 Nm
    GJ0023318
  13. Refer to: CATALYTIC CONVERTER .
  14. Refer to: BATTERY DISCONNECT AND CONNECT .
scientia non olet · About LEMON Manuals