Exhaust Manifold LH: Installation

All vehicles 

1. Torque: 45 Nm
NOTE: Install a new gasket.
2. Install the special tool.

   Special Tool(s): 303-1444-01, 303-1444-02

NOTE: If a new cylinder head is installed use the special tools in the illustration.
3. Install the special tool.

   Special Tool(s): 303-1444-02

CAUTION: Make sure that new bolts are installed.
NOTE: Install the spacers in the noted position.
4. Torque: 10 Nm
5. Remove the special tool.
CAUTION: Make sure that new bolts are installed.
NOTE: Install the spacers in the noted position.
6. Torque: 10 Nm
7. Torque: 18 Nm
8. See figure
9. Refer to: CATALYTIC CONVERTER .
10. See figure.

Left-hand drive vehicles 

11. Torque: 100 Nm
WARNING: Make sure that a new bolt is installed.
NOTE: Some variation in the illustrations may occur, but the essential information is always correct.
12. Torque: 35 Nm

All vehicles 

13. Torque: 25 Nm
14. Torque: 25 Nm
15. Torque: 10 Nm
16. Torque: 10 Nm
17. Torque: 25 Nm
18. Torque: 3 Nm
19. Torque: 3 Nm
20. Refer to: POWER STEERING PUMP .
21. Refer to: BATTERY DISCONNECT AND CONNECT .