LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 89 (Engine - V8 S/C 5.0L Petrol) >> Engine (V8 S/C 5.0L Petrol) >> Removal and Installation >> Cylinder Head >> Installation

Cylinder Head: Installation

WARNING: This page is about a different car, the 2011 Jaguar XKR175, 2011 Jaguar XKR, and 2010 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: An acceptable flatness of the cylinder head is 0.1mm.
    NOTE: For cylinder head with distortion above the maximum allowance, the cylinder head material must be measured.
  1. Check cylinder head face for distortion, across the center and from corner to corner.
    G08770454
    2. WARNING: Make sure care is taken when handling the cylinder head gasket.
    CAUTION: The head gasket must be installed over the cylinder block dowels.
    NOTE: Install a new cylinder head gasket.
  2. See figure.
    GJ0012091
    3. CAUTION: Make sure that new cylinder head bolts are installed.
    NOTE: Tighten the bolts in the indicated sequence.
  3. Torque: 20 Nm
    GJ0012092
    4. NOTE: Tighten the bolts in the indicated sequence.
  4. Torque: 35 Nm
    GJ0012092
    5. NOTE: Tighten the bolts in the indicated sequence.
  5. Torque: 90°
    GJ0012092
    6. NOTE: Tighten the bolts in the indicated sequence.
  6. Torque: 120°
    GJ0012092
  7. Torque: 25 Nm
    GJ0012093
    8. NOTE: Tighten the bolts in the indicated sequence.
  8. Torque: 12 Nm
    GJ0012094
    9. CAUTION: Install the new seals.
  9. Torque: 10 Nm
    GJ0012086
  10. See figure.
    GJ0012833
  11. Refer to: Exhaust Manifold LH  .
  12. Refer to: Camshaft LH  .
  13. Refer to: BATTERY DISCONNECT AND CONNECT .
scientia non olet · About LEMON Manuals