LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 89 (Engine - V8 S/C 5.0L Petrol) >> Engine (V8 S/C 5.0L Petrol) >> Removal and Installation >> Camshaft LH >> Removal

Camshaft LH: Removal

WARNING: This page is about a different car, the 2011 Jaguar XKR175, 2011 Jaguar XKR, and 2010 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Make sure that the orientation and code on the top of the camshaft bearing caps is noted (along with the bank - A or B), so that on installation the components are installed to their original position. Failure to follow this instruction may cause damage to the vehicle.
NOTE: Removal steps in this procedure may contain installation details.
  1. Refer to: BATTERY DISCONNECT AND CONNECT .
    2. WARNING: Make sure to support the vehicle with axle stands.
  2. Raise and support the vehicle.
  3. Refer to: Timing Drive Components Assembly Part Number: INA Timing Drive  or Timing Drive Components Assembly Part Number: Tsubaki Timing Drive  .
    4. CAUTION:

    Rotate the camshafts until all the valves are at their minimum open point.

    Evenly and progressively, release the camshaft bearing caps.

    NOTE: Remove the camshaft bearing caps. Note: their position, orientation and markings. Each is marked with its position (number) and an orientation (arrow).
  4. See figure.
    GJ0016199
scientia non olet · About LEMON Manuals