Audio Amplifier Module (AAM)

WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Diagnosis by substitution from a donor vehicle is NOT acceptable. Substitution of control modules does not guarantee confirmation of a fault, and may also cause additional faults in the vehicle being tested and/or the donor vehicle

When probing connectors to take measurements in the course of the pinpoint tests, use the adaptor kit, part number 3548-1358-00

NOTE: If the control module or a component is suspect and the vehicle remains under manufacturer warranty, refer to the warranty policy and procedures manual (section B1.2), or determine if any prior approval programme is in operation, prior to the installation of a new module/component.

Generic scan tools may not read the codes listed, or may read only 5-digit codes. Match the 5 digits from the scan tool to the first 5 digits of the 7-digit code listed to identify the fault (the last 2 digits give extra information read by the manufacturer-approved diagnostic system)

When performing voltage or resistance tests, always use a digital multimeter accurate to three decimal places and with a current calibration certificate. When testing resistance, always take the resistance of the digital multimeter leads into account

Check and rectify basic faults before beginning diagnostic routines involving pinpoint tests

Inspect connectors for signs of water ingress, and pins for damage and/or corrosion

If diagnostic trouble codes are recorded and, after performing the pinpoint tests, a fault is not present, an intermittent concern may be the cause. Always check for loose connections and corroded terminals

Where an 'on demand self-test' is referred to, this can be accessed via the 'diagnostic trouble code monitor' tab on the manufacturers approved diagnostic system

The table below lists all Diagnostic Trouble Codes (DTCs) that could be logged in the Audio Amplifier Module, for additional Diagnosis and Testing information. For additional information, refer to AUDIO SYSTEM .

DTC	Description	Possible Cause	Action
B1A01-13	Speaker #1 - circuit open	Front passenger speaker circuits - high resistance	Refer to the electrical circuit diagrams and test front passenger speaker circuits for high resistance.
B1A02-13	Speaker #2 - circuit open	Front driver speaker circuits - high resistance	Refer to the electrical circuit diagrams and test front driver speaker circuits for high resistance.
B1A03-13	Speaker #3 - circuit open	Rear left speaker circuit - high resistance	Refer to the electrical circuit diagrams and test rear left speaker circuit for high resistance.
B1A04-13	Speaker #4 - circuit open	Rear right speaker circuit - high resistance	Refer to the electrical circuit diagrams and test rear right speaker circuit for high resistance.
B1A05-13	Speaker #5 - circuit open	Front center speaker circuit - high resistance	Refer to the electrical circuit diagrams and test front center speaker circuit for high resistance.
B1A06-13	Speaker #6 - circuit open	Sub-woofer speaker circuit - high resistance	Refer to the electrical circuit diagrams and test sub-woofer speaker circuit for high resistance.
B1A01-01	Speaker#1 - general electrical failure	General electrical failure	Carry out the pinpoint test associated with this DTC using the manufacturer approved diagnostic system.
B1A02-01	Speaker #2 - general electrical failure	General electrical failure	Carry out the pinpoint test associated with this DTC using the manufacturer approved diagnostic system.
B1A03-01	Speaker #3 - general electrical failure	General electrical failure	Carry out the pinpoint test associated with this DTC using the manufacturer approved diagnostic system.
B1A04-01	Speaker #4 - general electrical failure	General electrical failure	Carry out the pinpoint test associated with this DTC using the manufacturer approved diagnostic system.
B1A05-01	Speaker #5 - general electrical failure	General electrical failure	Carry out the pinpoint test associated with this DTC using the manufacturer approved diagnostic system.
B1A06-01	Speaker #6 - general electrical failure	General electrical failure	Carry out the pinpoint test associated with this DTC using the manufacturer approved diagnostic system.
B1A09-11	Short circuit of one or both front speaker output - circuit short to ground	Short to ground	Check for additional front speaker DTCs and refer to DTC Index.
B1A10-11	Short circuit of one or both rear speaker output - circuit short to ground	Short to ground	Check for additional rear speaker DTCs and refer to DTC Index.
B1A11-12	Speaker#11 - circuit short to battery	Short to power	Refer to the electrical circuit diagrams and check all speaker circuits for short to power.
U2003-98	Fibre optic communication Bus - component or system over temperature	Component or system over temperature	Check for additional DTCs and refer to DTC Index. Clear DTC and re-test/monitor condition.
U3000-05	Control module - system programming failures	Software incompatibility The version of the Local Configuration file does not match that expected	Re-configure the audio amplifier as an existing control module, using the manufacturer approved diagnostic system.
U3000-42	Control module - general memory failure	General memory failure	Re-configure the audio amplifier as an existing control module, using the manufacturer approved diagnostic system. Clear DTC, cycle ignition and read DTCs. If DTC returns, suspect audio amplifier module and install a new module. Refer to the new module installation note at the top of the DTC Index.
U3000-44	Control module - data memory failure	Data memory failure	Re-configure the audio amplifier as an existing control module, using the manufacturer approved diagnostic system. Clear DTC, cycle ignition and read DTCs. If DTC returns, suspect audio amplifier module and install a new module. Refer to the new module installation note at the top of the DTC Index.
U3000-55	Stored vehicle configuration data does not match - not configured	Incorrect car configuration data received	Re-configure the RJB using the manufacturer approved diagnostic system. Clear DTC and re-test. If the DTC remains suspect the audio amplifier. Refer to the new module installation note at the top of the DTC Index.
U3000-87	Control module - missing message	Missing message	Re-configure the RJB using the manufacturer approved diagnostic system. Check audio amplifier for DTCs and refer to the DTC Index. Check CAN network integrity using the manufacturer approved diagnostic system.
U3000-98	Control module - component or system over temperature	Component or system over temperature	Check for additional DTCs and refer to DTC Index. Clear DTC and re-test/monitor condition.
U3003-16	Battery voltage - circuit voltage below threshold	Circuit voltage below threshold	Carry out the pinpoint test associated with this DTC using the manufacturer approved diagnostic system.
U3003-17	Battery voltage - circuit voltage above threshold	Circuit voltage above threshold	Carry out the pinpoint test associated with this DTC using the manufacturer approved diagnostic system.
U3006-12	Control module - circuit short to battery	Short to power	Install a new audio amplifier module, refer to the new module installation note at the top of the DTC Index.
U3006-16	Control module - circuit voltage below threshold	Circuit voltage below threshold	Install a new audio amplifier module, refer to the new module installation note at the top of the DTC Index.