LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 80 (Parking Aid) >> Parking Aid >> Removal And Installation >> Rear Parking Aid Sensor >> Removal

Rear Parking Aid Sensor: Removal

WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
    WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
  1. Raise and support the vehicle.
  2. Remove the rear bumper cover. Refer to Rear Bumper Cover information.
  3. Remove the parking aid sensor.
    • Disconnect the electrical connector.
    • Release the 2 clips.
    • Repeat the above for the other 3 sensors.
      GJ0010247
scientia non olet · About LEMON Manuals