LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 80 (Parking Aid) >> Parking Aid >> Removal And Installation >> Parking Aid Module >> Installation

Parking Aid Module: Installation

WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the parking aid module.
    • Connect the electrical connectors.
    • Tighten the nuts to 3 Nm (2 lb.ft).
    • Secure the electrical harness.
    • Align the acoustic pad.
  2. Install the subwoofer cover.
    • Tighten the bolts to 10 Nm (7 lb.ft).
    3. CAUTION: Make sure the carpet is correctly installed and that no foul-condition exists when the accelerator pedal is depressed.
  3. Install the carpet.
    • Install the floor console side panel trim.
  4. Install the cowl side trim panel.
    • Carefully align and secure the clips.
    • Secure the scuff plate trim panel.
  5. Connect the battery ground cable and install the cover. Refer to Specifications information.
scientia non olet · About LEMON Manuals