LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 77 (Audio Unit) >> Audio Unit >> Removal And Installation >> Amplifier >> Removal

Removal And Installation: Amplifier: Removal

WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The component is situated in the passenger footwell. LHD is illustrated the procedure to remove the component on a RHD vehicle is similar.
  1. Remove the instrument panel assembly. Refer to Instrument Panel information.
  2. Remove the heater duct.
    • Remove the 2 Torx screws.
    • Release the lampholder.
      GJ0009327
    3. CAUTION: Make sure the wiring harness and electrical connectors are not damaged during the carpet release.
  3. Carefully release the carpet for access.
  4. Remove the subwoofer cover.
    • Remove the 4 bolts.
      GJ0009328
    5. CAUTION: Cover fibre optic cable connectors to minimize dust ingress and avoid bending the cables in a radius of less than 30 mm.
  5. Disconnect the 2 electrical connectors.
    • Carefully disconnect the MOST connector.
  6. Remove the amplifier.
    • Remove the 4 Torx screws.
      GJ0009329
scientia non olet · About LEMON Manuals