LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 77 (Audio Unit) >> Audio Unit >> Removal And Installation >> Amplifier >> Installation

Removal And Installation: Amplifier: Installation

WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the amplifier.
  2. Connect the electrical connectors.
    • Connect the MOST connector.
  3. Install the subwoofer cover.
    • Tighten the bolts to 10 Nm (7 lb.ft).
    4. CAUTION: Make sure the carpet is correctly installed and that no foul-condition exists when the accelerator pedal is depressed.
  4. Install the carpet.
  5. Install the heater duct.
    • Install the Torx screws.
    • Install the lampholder.
  6. Install the instrument panel assembly. Refer to Instrument Panel information.
scientia non olet · About LEMON Manuals