LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (Wheels & Tires) >> Wheels And Tires >> Removal And Installation >> Tire Pressure Monitoring System Module - Convertible >> Installation

Tire Pressure Monitoring System Module - Convertible: Installation

WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the tire pressure monitoring module.
    • Tighten the nuts to 10 Nm (7 lb.ft).
    • Connect the electrical connectors.
  2. Secure the auxiliary junction box mounting bracket.
    • Tighten the nuts to 10 Nm (7 lb.ft).
  3. Install the rear seat RH backrest retaining bracket.
    • Tighten the nuts and bolts to 10 Nm (7 lb.ft).
  4. Install the RH roll over protection unit.
    • Tighten the Torx bolts to 25 Nm (18 lb.ft).
    • Connect the electrical connector.
  5. Install the LH roll over protection unit.
  6. Connect the battery ground cable and install the cover. Refer to SPECIFICATIONS information.
  7. Using WDS, configure a new module.
scientia non olet · About LEMON Manuals