Timing Cover: Installation
WARNING: This page is about a different car, the 2011 Jaguar XK and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
- Torque: 12 Nm
- Torque: 12 Nm
- Apply RTV sealant WSE-M4G323-A6 (Loctite 5901G) to the areas shown, and tighten the bolts within 7 minutes.
- Install the bolts, but do not tighten fully at this stage.
Lower Timing Cover Alignment tool (303-1433)
- Torque:
M6 12 Nm
M8 20 Nm
- Torque: 12 Nm
- Torque: 12 Nm
- Torque: 12 Nm
- Torque: 40 Nm
- Torque: 40 Nm
- Refer to Crankshaft Pulley .
- Refer to Valve Cover RH .
- Refer to Valve Cover LH .
- Refer to Thermostat Housing - V8 5.0L Petrol information.
- Refer to Accessory Drive Belt (V8 N/A 5.0L Petrol) information.
- Refer to Battery Disconnect and Connect information.
CAUTION:
Make sure that the mating faces are clean and free of foreign material.
CAUTION:
Make sure that the mating faces are clean and free of foreign material.
NOTE:
Tighten the bolts in the indicated sequence.
NOTE:
Tighten the bolts in the indicated sequence.
CAUTION:
Make sure that the mating faces are clean and free of foreign material.
NOTE:
Tighten the bolts in the indicated sequence.
NOTE:
Install the bolt finger tight before final tightening.