LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 69 (Engine (V8 5.0L Petrol)) >> Engine (V8 5.0L Petrol) >> Removal And Installation >> Oil Cooler >> Removal

Oil Cooler: Removal

WARNING: This page is about a different car, the 2011 Jaguar XK and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Removal steps in this procedure may contain installation details.
  1. Refer to Battery Disconnect and Connect information.
    2. WARNING: Make sure to support the vehicle with axle stands.
  2. Raise and support the vehicle.
  3. Refer to Intake Manifold .
  4. Refer to Cooling System Draining, Filling and Bleeding - Vehicles Without: Supercharger or Cooling System Draining, Filling and Bleeding - Vehicles Without: Supercharger information.
  5. See figure
    GJ0012833
  6. See figure
    GJ0012834
    7. CAUTION: Be prepared to collect escaping oil.
    CAUTION: Be prepared to collect escaping coolant.
  7. Torque: 13 Nm
    GJ0012835
    8. CAUTION: Make sure that these components are installed to the noted removal position.
    NOTE: Install a new gasket.
  8. See figure
    GJ0012836
    9. CAUTION: Make sure that these components are installed to the noted removal position.
    CAUTION: Install new o-ring seals
  9. See figure
    GJ0012837
scientia non olet · About LEMON Manuals