Exhaust Manifold: Installation

WARNING: This page is about a different car, the 2011 Jaguar XK and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.

All vehicles

Torque: 45 Nm

NOTE: Install a new gasket.

Install the special tool.
Exhaust Manifold Installation Guide Pins - Threaded (303-1444-01)

Exhaust Manifold Installation Guide Pins - Unthreaded (303-1444-02)

NOTE: If a new cylinder head is installed use the special tools in the illustration.

Install the special tool.
Exhaust Manifold Installation Guide Pins - Unthreaded (303-1444-02)

CAUTION: Make sure that new bolts are installed.

NOTE: Install the spacers in the noted position.

Torque: 10 Nm
Remove the special tool.

CAUTION: Make sure that new bolts are installed.

NOTE: Install the spacers in the noted position.

Torque: 10 Nm
Torque: 18 Nm
See figure
Refer to Catalytic Converter information.
See figure

Left-hand drive vehicles

Torque: 100 Nm

WARNING: Make sure that a new bolt is installed.

NOTE: Some variation in the illustrations may occur, but the essential information is always correct.

Torque: 35 Nm

All vehicles

Torque: 25 Nm
Torque: 25 Nm
Torque: 10 Nm
Torque: 10 Nm
Torque: 25 Nm
Torque: 3 Nm
Torque: 3 Nm
Refer to Power Steering Pump information.
Refer to Battery Disconnect and Connect information.