LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 69 (Engine (V8 5.0L Petrol)) >> Engine (V8 5.0L Petrol) >> Removal And Installation >> Cylinder Head RH >> Removal

Cylinder Head RH: Removal

WARNING: This page is about a different car, the 2011 Jaguar XK and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Removal steps in this procedure may contain installation details.
  1. Refer to Battery Disconnect and Connect information.
  2. Raise and support the vehicle.
  3. Refer to Intake Manifold .
  4. Refer to Camshaft RH .
  5. Refer to EXHAUST MANIFOLD LH information.
  6. See figure
    GJ0012143
  7. See figure
    GJ0012130
    8. CAUTION: Discard the seal.
    CAUTION: LH illustration shown, RH is similar.
    NOTE: Engine shown removed for clarity.
  8. See figure
    GJ0012131
  9. See figure
    GJ0012082
  10. See figure
    GJ0012132
    11. NOTE: Clamp the hose to minimize coolant loss.
  11. See figure
    GJ0023314
    12. NOTE: Clamp the hose to minimize coolant loss.
  12. See figure
    GJ0012084
  13. See figure
    GJ0012085
    14. CAUTION: Discard the seals.
  14. See figure
    GJ0012086
  15. See figure
    GJ0016203
    16. NOTE: Remove and discard the O-ring seal.
  16. See figure
    GJ0012135
    17. NOTE: Discard the gasket.
  17. See figure
    GJ0012136
  18. See figure
    GJ0012137
    19. CAUTION: If a new cylinder head has been installed then new tappets must be installed.
    CAUTION: If the cylinder head is being removed without a new component being installed, the tappets must be installed in their original positions.
  19. See figure
    GJ0012089
    20. CAUTION: Discard the bolts.
  20. See figure
    GJ0012140
    21. NOTE: Discard the gasket.
  21. See figure
    GJ0012139
scientia non olet · About LEMON Manuals