LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 69 (Engine (V8 5.0L Petrol)) >> Engine (V8 5.0L Petrol) >> General Procedures >> Engine Oil Vacuum Draining And Filling >> Filling

Engine Oil Vacuum Draining And Filling: Filling

WARNING: This page is about a different car, the 2011 Jaguar XK and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Install new O-ring seals.
  1. Lubricate the oil filter element O-ring seal with clean engine oil.
    GJ0012842
    2. CAUTION: Tighten the component finger tight first.
    • Torque: 25 Nm
      GJ0022906
    3. CAUTION: Make sure that the vehicle is left for 5 minutes from filling with oil and that the engine oil level is reading at least minimum (by following Steps 7-11), before starting the engine.
    • Fill the engine with oil - for filling values on vehicles without supercharger:

      Refer to Specifications  information.

    • Fill the engine with oil - for filling values on vehicles with supercharger:

      Refer to SPECIFICATIONS information.

    • Clean any residual engine oil from the oil filler cap area.
  4. See figure
    G00531275
    5. CAUTION: Make sure that the vehicle has been left for 5 minutes from filling with oil.
  5. Follow the Steps 7-11 before starting the engine.
    • Start the engine and allow to run for 10 minutes, stop the engine.
    • Check for leaks.
    7. CAUTION: Make sure that the selector lever and the gearshift mechanism are in the park (P) position.
    CAUTION: Make sure that the hood is open.
    • Turn the ignition on.
    • Scroll through the trip menu to access the engine oil level display.
      GJ0023401
    • Press the cruise control cancel button twice within 2 seconds.
      GJ0023402
    • The message center display will revert to the normal display in the trip computer.
    • Scroll through the trip menu to access the engine oil level display.
    • Check that the oil level display shows an oil level reading.
    • Only after having started and run the engine for 10 minutes (as indicated in Step 6), switch off the engine, then stabilizing for 10 minutes, take a reading from the oil level display and, if necessary top up with engine oil.
      GJ0023403
    11. NOTE: If instructed to follow Steps 7-11 in a previous step, return to Step 6 and continue the procedure.
  11. Turn the ignition off.
  12. Allow 10 minutes for the engine oil level to stabilize if there has been additional oil top up.
    13. NOTE: The following steps are to update the average oil level value.
    • Turn the ignition on.
    • Press and hold the cruise control cancel button for more than 2 seconds.
      GJ0023402
    • The message center display will revert to the normal display in the trip computer.
  15. Turn the ignition off.
  16. Turn the ignition on.
    • Scroll through the trip menu to access the engine oil level display.
    • Make sure that the average oil level value has now been updated.
      GJ0023403
  18. Refer to Engine Cover information.
scientia non olet · About LEMON Manuals