Steering Gear Boot: Installation
WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
- Install the steering gear boot.
- Clean the component mating faces.
- Carefully secure the clips.
- Install the locknut.
- Install the tie-rod end. Refer to Tie Rod End - 5.0L .
- Using only four-wheel alignment equipment approved by Jaguar, check and adjust the wheel alignment. Refer to Front Toe Adjustment article.
NOTE:
Align to the position noted on removal.