Speed Control DEACTIVATOR Switch: Removal

WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: This component also functions as the brake pedal switch.

CAUTION: Removal of the clips is a delicate procedure, damage will occur if any force is used.

Remove the driver's side footwell trim panel.
- Carefully release the 3 clips.
Release the brake switch.
- Rotate clockwise approximately 30 degrees.
- Carefully release the clip.
- Disconnect the electrical connector.