Speed Control DEACTIVATOR Switch: Installation
WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
During installation of the brake switch, make sure the brake pedal is not depressed at any time. Depressing the pedal may cause: poor operation of the brake light switch and brake lights, diagnostic trouble codes to be logged and/or failure of the vehicle to start.
- Install the brake switch.
- Connect the electrical connector.
- Secure the clip.
- Install the driver's side footwell trim panel.
- Carefully align and secure the clips.