LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 64 (Power Brake Actuation) >> Power Brake Actuation >> Removal And Installation >> Brake Booster - LHD RWD >> Removal

Brake Booster - LHD RWD: Removal

WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the brake master cylinder. Refer to Brake Master Cylinder - LHD information.
    2. CAUTION: Removal of the clips is a delicate procedure, damage will occur if any force is used.
  2. Remove the driver's side footwell trim panel.
    • Carefully release the 3 clips.
      GJ0009603
  3. Release the brake switch.
    • Rotate clockwise approximately 30 degrees.
      GJ0009638
  4. Release the vacuum pipe.
    GJ0009639
  5. Remove the brake booster.
    • Remove the brake pedal clevis pin.
    • Remove the 4 nuts.
      GJ0009640
  6. Remove and discard the gasket.
scientia non olet · About LEMON Manuals