Brake Pads Vehicles With: High Performance Brakes: Installation
WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
- Press the piston into the caliper housing.
- See figure
- See figure
- See figure
- See figure
- Repeat the above procedure on the opposite side.
- Refer to Wheel and Tire information.
WARNING:
Do not use compressed air to clean brake components. Dust from friction materials can be harmful if inhaled.
CAUTION:
As the piston is pushed back into the caliper housing, the brake fluid level in the reservoir will rise. Do not allow the reservoir to overflow.
NOTE:
Left-hand shown, right-hand similar.
NOTE:
Left-hand shown, right-hand similar.
NOTE:
Left-hand shown, right-hand similar.
NOTE:
Left-hand shown, right-hand similar.
CAUTION:
Make sure that the road wheels are in the straight ahead position.
CAUTION:
Make sure that excessive force is not used. Failure to follow this instruction may result in damage to the vehicle.
CAUTION:
Make sure that the brake hose is not twisted and is correctly located.