LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 60 (Front Disc Brake) >> Front Disc Brake >> Removal And Installation >> Brake Caliper - Vehicles With: Standard Brakes >> Removal

Brake Caliper - Vehicles With: Standard Brakes: Removal

WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Brake fluid will damage paint finished surfaces. If spilled, immediately remove the fluid and clean the area with water.
NOTE: Removal steps in this procedure may contain installation details.
    WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
  1. Raise and support the vehicle.
  2. Remove the left-hand front wheel and tire. Refer to Wheel and Tire information.
  3. See figure
    GJ0022536
    4. CAUTION: Always plug any open connections to prevent contamination.
    NOTE: To prevent the loss of brake fluid, using the special tool apply the brake pedal and set to 40mm (1.6 in) below the rest position.
    • Remove and discard the two sealing washers.
      GJ0022553
    5. CAUTION: Removal of the clips is a delicate procedure, damage will occur if any force is used.
    • Lever the anti-rattle spring in the center of the spring until either side is released.
      GJ0009011
    6. WARNING: If the brake caliper piston seal is damaged a new brake caliper must be installed.
    CAUTION: Do not allow the brake caliper to hang on the brake hose.
    NOTE: Left-hand shown, right-hand similar.
  6. See figure
    GJ0009000
    • Release the clip.
      GJ0009001
  8. See figure
    GJ0009002
scientia non olet · About LEMON Manuals