Brake Caliper - Vehicles With: High Performance Brakes: Removal
WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Brake fluid will damage paint finished surfaces. If spilled, immediately remove the fluid and clean the area with water.
NOTE:
Removal steps in this procedure may contain installation details.
- Raise and support the vehicle.
- Remove the left-hand front wheel and tire. Refer to Wheel and Tire information.
- See figure
- See figure
- See figure
- See figure
- See figure
- See figure
WARNING:
Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
CAUTION:
Always plug any open connections to prevent contamination.
NOTE:
To prevent the loss of brake fluid, using the special tool apply the brake pedal and set to 40mm (1.6 in) below the rest position.
NOTE:
Left-hand shown, right-hand similar.
NOTE:
Remove and discard the two sealing washers.
NOTE:
Left-hand shown, right-hand similar.
CAUTION:
Removal of the clips is a delicate procedure, damage will occur if any force is used.
NOTE:
Left-hand shown, right-hand similar.
WARNING:
If the brake caliper piston seal is damaged a new brake caliper must be installed.
CAUTION:
Do not allow the brake caliper to hang on the brake hose.
NOTE:
Left-hand shown, right-hand similar.
NOTE:
Left-hand shown, right-hand similar.
NOTE:
Left-hand shown, right-hand similar.