Power Steering System Filling: Filling
WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
- Torque: 20 Nm
-
- Fill the power steering reservoir.
- Install the vacuum hand pump to the power steering fluid reservoir.
- Apply a vacuum to the power steering fluid reservoir.
- Remove the vacuum hand pump from the power steering fluid reservoir.
-
- Fill the power steering reservoir.
-
- Run the engine for 30 seconds.
- Turn the steering fully lock-to-lock, stop the engine.
- Install the vacuum hand pump to the power steering fluid reservoir.
- Apply a vacuum to the power steering fluid reservoir.
- Remove the vacuum hand pump from the power steering fluid reservoir.
-
- Fill the power steering reservoir.
-
- Run the engine for 30 seconds.
- Turn the steering fully lock-to-lock, stop the engine
- Install the vacuum hand pump to the power steering fluid reservoir.
- Apply a vacuum to the power steering fluid reservoir.
- Remove the vacuum hand pump from the power steering fluid reservoir.
-
- Fill the power steering reservoir.
-
- Run the engine for 30 seconds.
- Turn the steering fully lock-to-lock, stop the engine.
-
- Install the power steering fluid reservoir cap.
- Refer to Air Deflector information.
NOTE:
Make sure that the component is clean, free of foreign material and lubricant.
CAUTION:
Fluid must always be present in the reservoir during bleeding.
NOTE:
Apply the maximum vacuum possible on the reservoir for 1 minute.
CAUTION:
Fluid must always be present in the reservoir during bleeding.
NOTE:
Apply the maximum vacuum possible on the reservoir for 1 minute.
CAUTION:
Fluid must always be present in the reservoir during bleeding.
NOTE:
Apply the maximum vacuum possible on the reservoir for 1 minute.
CAUTION:
Fluid must always be present in the reservoir during bleeding.