Rear Toe Adjustment
WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Make sure the vehicle is on a flat level surface.
CAUTION:
Make sure the tire pressures are within specification.
CAUTION:
Make sure that only the manufacturers' recommended four wheel alignment equipment is used.
CAUTION:
Make sure the steering is in the straight ahead position.
- For wheel alignment information, refer to the suspension specification section. Refer to Specifications . .
- Check the tie rod ends, suspension joints, wheel bearings and wheels and tires for damage, wear and free play.
- Adjust or repair any worn, damaged or incorrectly adjusted components.
- Check and adjust tire pressures.
- Position the vehicle on a calibrated, level, vehicle lift.
- Release the vehicle parking brake.
- Using only four-wheel alignment equipment approved by Jaguar, check the wheel alignment.
- To adjust, loosen the toe link locknuts.
- Adjust the rear toe.
- Tighten the toe link locknuts to 55 Nm (40 lb.ft).
- Using only four-wheel alignment equipment approved by Jaguar, check the wheel alignment.
NOTE:
LH illustration shown, RH is similar.
CAUTION:
Do not allow the gaiter to twist.
NOTE:
Both tie rods must be rotated by an equal amount.
NOTE:
LH illustration shown, RH is similar.