LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 53 (Uni-Body, SUBFRAME & Mounting System) >> Uni-Body, SUBFRAME And Mounting System >> Removal And Installation >> Rear SUBFRAME Rear Bushing >> Removal

Rear SUBFRAME Rear Bushing: Removal

WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.

    All vehicles 

  1. Disconnect the battery ground cable. Refer to Specifications information.
    2. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
  2. Raise and support the vehicle.

    3. Vehicles with 4.2L engine 

  3. Remove the rear subframe assembly. Refer to Rear Subframe - 4.2L . .

    4. Vehicles with 5.0L engine 

  4. Remove the rear subframe assembly. Refer to Rear Subframe - 5.0L .

    5. All vehicles 

    NOTE: Note the fitted position.
  5. Using the special tools, remove and discard the rear subframe rear bushing.
    GJ0004569
scientia non olet · About LEMON Manuals