LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 52 (Front Suspension) >> Front Suspension >> Removal And Installation >> Wheel Knuckle >> Installation

Wheel Knuckle: Installation

WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Use an additional wrench to prevent the ball joint rotating.
  1. Install the wheel knuckle.
    • Clean the component mating faces.
    • Tighten the nut to 92 Nm.
  2. Install the brake disc shield.
    • Install the rivets.
    • Repeat the above procedure for the other side.
    3. NOTE: Use an additional wrench to prevent the ball joint rotating.
  3. Connect the upper arm and wheel knuckle.
    • Tighten the nut to 90 Nm.
    4. NOTE: Use an additional wrench to prevent the component from rotating.
  4. Connect the tie-rod end ball joint.
    • Tighten the nut to 55 Nm.
  5. Install the hub assembly. See Front Wheel Bearing and Wheel Hub .
scientia non olet · About LEMON Manuals