LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 52 (Front Suspension) >> Front Suspension >> Removal And Installation >> Rear Lower Arm >> Installation

Rear Lower Arm: Installation

WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Align to the position noted on removal.
  1. Install the lower suspension arm.
    • Tighten the nut and bolt to 175 Nm.
  2. Install the forward lower control arm.
    • Install the bolt and tighten the new nut to 60 Nm + 135 degrees.
    3. NOTE: Use an additional wrench to prevent the ball joint rotating.
  3. Install the lower arm ball joint
    • Clean the component mating faces.
    • Tighten the nut to 92 Nm.
    4. NOTE: Use an additional wrench to prevent the component from rotating.
  4. Install the stabilizer bar link.
    • Tighten the nuts to 43 Nm.
  5. Connect the height sensor link.
  6. Install the wheel and tire. Refer to Wheel and Tire information.
  7. Using only four-wheel alignment equipment approved by Jaguar, check the wheel alignment, and adjust if required.
scientia non olet · About LEMON Manuals