LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 52 (Front Suspension) >> Front Suspension >> Removal And Installation >> Front Wheel Bearing And Wheel Hub - V8 5.0L Petrol/V8 S/C 5.0L Petrol >> Removal

Front Wheel Bearing And Wheel Hub - V8 5.0L Petrol/V8 S/C 5.0L Petrol: Removal

WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Removal steps in this procedure may contain installation details.
    WARNING: Make sure to support the vehicle with axle stands.
  1. Raise and support the vehicle.
  2. Torque: 112 Nm
    GJ0008904
  3. Torque: 10 Nm
    GJ0025727
    4. NOTE: LH illustration shown, RH is similar.
  4. See figure
    GJ0025728
    5. CAUTION: Discard the bolts.
    NOTE: LH illustration shown, RH is similar.
    NOTE: Secure with cable ties.
  5. Torque: 115 Nm
    GJ0023277
    6. NOTE: LH illustration shown, RH is similar.
  6. See figure
    GJ0009004
    7. CAUTION: Discard the bolts.
    CAUTION: Make sure that the area around the component is clean and free of foreign material.
    CAUTION: Do not attempt to release the wheel hub by hitting it with a hammer directly, loosen the wheel hub retaining bolts partially before applying an even amount of force to the head of each bolts to release the wheel hub from the wheel knuckle. Failure to follow this instruction may cause damage to the component.
    NOTE: Some variation in the illustrations may occur, but the essential information is always correct.
    NOTE: LH illustration shown, RH is similar.
    NOTE: Install the components to their original fitted positions.
  7. Torque: 90 Nm
    GJ0023278
scientia non olet · About LEMON Manuals