Front Wheel Bearing And Wheel Hub - V8 4.2L Petrol/V8 S/C 4.2L Petrol: Removal
WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
- Raise and support the body.
- Remove the LH front brake disc. Refer to Brake Disc - Vehicles With: Standard Brakes information.
- Remove the LH stabilizer bar link.
- Remove the wheel speed sensor.
- Release the clip.
- Tie aside.
- LH front: Carefully remove the hub assembly.
WARNING:
Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
NOTE:
Use an additional wrench to prevent the ball joint rotating.
CAUTION:
Do not attempt to release the wheel hub by hitting it with a hammer directly, loosen the wheel hub retaining bolts partially before applying an even amount of force to the head of each bolts to release the wheel hub from the wheel knuckle. Failure to follow this instruction may cause damage to the component.
NOTE:
Note the fitted position.