Front Wheel Bearing And Wheel Hub - V8 4.2L Petrol/V8 S/C 4.2L Petrol: Installation

WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Align to the position noted on removal.

NOTE: Make sure that all the component mating faces are clean.

LH front: Carefully install the hub assembly.
- Clean the component mating faces.
- Tighten the bolts to 90 Nm (66 lb.ft).
Install the wheel speed sensor.
- Secure the clip.

NOTE: Use an additional wrench to prevent the ball joint rotating.

Install the stabilizer bar link.
- Tighten the nuts to 48 Nm (35 lb.ft).
Install the brake disc. Refer to Brake Disc - Vehicles With: Standard Brakes information.