Front Lower Arm: Installation
WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
- Install the forward lower control arm.
- Install the bolt and tighten the new nut to 60 Nm (44 lb.ft) + 135 degrees.
- Tighten the 14mm bolt to 175 Nm (129 lb.ft).
- Install the wheel and tire. Refer to Wheel and Tire information.
- Using only four-wheel alignment equipment approved by Jaguar, check the wheel alignment, and adjust if required.