LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 51 (Air Conditioning) >> Air Conditioning >> Removal And Installation >> Thermostatic Expansion Valve >> Installation

Thermostatic Expansion Valve: Installation

WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Lubricate the new seals with clean refrigerant oil.
    NOTE: Make sure all component mating faces are clean.
  1. Install the TXV assembly.
    • Install the new O-ring seals.
    • Install and tighten the Allen bolts to 6 Nm (4 lb.ft).
    • Replace the TXV insulation.
  2. Install the heater and evaporator core housing. Refer to Heater Core and Evaporator Core Housing information.
  3. Connect the battery ground cable and install the cover. Refer to Specifications information.
scientia non olet · About LEMON Manuals